Extrusion board is a kind of green and environmental protection thermal insulation material, which has the characteristics of good thermal insulation, high strength and good corrosion resistance. Therefore, many customers can choose Extrusion board in home decoration, but when pasting, it is necessary to pay attention to the following points:
1.施工前，应做好挤塑板的布置，以达到节省材料，加快施工的目的。
1. Before construction, the layout of extruded plastic sheets should be done well in order to save materials and speed up construction.
2.将经过特殊基础处理的平板指定为模型层，以构建模型层。 一种
2. Designate the plate after special foundation treatment as the model layer to construct the model layer. one kind
3.用点涂法将涂有聚合物砂浆的挤塑板立即粘贴到墙上，并且速度必须快。
3. The Extrusion board coated with polymer mortar is imtely pasted to the wall by dot-coating method, and the speed must be fast.
4.按照预设的尺寸切割挤出的板材，并从拐角处垂直和垂直地连接它，并要求拐角在建筑物的整个“高处”必须笔直且完整。
4. Cut the extruded sheet according to the preset size and connect it vertically and vertically from the corner, and require the corner to be straight and complete throughout the "height" of the building.
5.从所需的中间边缘到加厚的周边，在每个挤出的片材上涂50毫米宽的抹泥刀专用聚合物粘结砂浆。
5. Coat each extruded sheet with polymer bonded mortar of 50 mm wide for plastering knife from the required middle edge to the thicker periphery.
6.粘贴挤压板时，应紧紧挤压挤压板的接缝，相邻的挤压板应均匀。 中国式施工期间，控制板的间距不应超过2m。
6. When pasting the extrusion plate, the joint of the extrusion plate should be squeezed tightly, and the adjacent extrusion plate should be even. During the construction of Chinese style, the spacing of control plates should not exceed 2m.
7. After pressing the board on the wall according to the above requirements, press 2 m ruler repeatedly to ensure its smoothness and firmness.
8.不允许将门窗开口处的挤压板与折断的板拼接在一起，整个板都用于切割。
8. It is not allowed to splice the extrusion plate at the opening of doors and windows with the broken plate. The whole plate is used for cutting.
9.挤压板应牢固粘贴，没有空鼓和松动。
9. The extrusion plate should be firmly pasted without empty drum and loosening.
10.为了防止外壁泄漏，需要在窗孔周围的挤压板与侧壁的子框架之间留出通槽。 中式
10. In order to prevent the leakage of the outer wall, it is necessary to leave a through groove between the extrusion plate around the window hole and the sub-frame of the side wall. Chinese style
11.在窗板之间，应考虑防水问题。 有关挤压板的更多信息，请访问我们的网站：
11. Waterproofing should be considered between window panels. For more inion about extrusion plates, please visit our website: .
